Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (MP3023 TRANSFER CASE (SERVICE INFORMATION))SENSOR, MODEINSTALLATION
2020 Dodge and Ram Durango GT, AWD
Sensor, Mode: Installation
2020 Dodge and Ram Durango GT, AWDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Align arrow (1) on the encoder shaft with alignment mark (2) prior to installing the encoder.NOTE:
Before installing the encoder onto the transfer case, be certain to align the encoder shaft to the shift shaft and the dowel on the encoder to the hole in the case accordingly.
- Install the encoder onto the rear transfer case housing.
- Install the encoder screws. Tighten the screws to the proper torque specifications Refer to SPECIFICATIONS .
- Install the electrical wiring harness connector onto the encoder.
- Place the heat shield, install and tighten the fasteners (1) securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.