Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (MP3023 TRANSFER CASE (SERVICE INFORMATION))MOTOR, SHIFTINSTALLATION
2020 Dodge and Ram Durango GT, AWD
Motor, Shift: Installation
2020 Dodge and Ram Durango GT, AWDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
Before installing the shift motor onto the transfer case, make certain that the shift motor shaft aligns with the transfer case worm shaft accordingly.
- Install a NEW shift motor O-ring seal onto the shift motor.
- Install the shift motor onto the transfer case.
- Install the shift motor bolts. Tighten the shift motor bolts to the proper torque specifications Refer to SPECIFICATIONS .
- Install the electrical wiring harness connector onto the shift motor.
- Place the heat shield, install and tighten the fasteners (1) securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.