Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Set Condition
This DTC sets when the EPPM no longer receives notification of the status update from the right pedestrian protection satellite acceleration sensor. Once set, this DTC is latched for the entire ignition cycle. This code will set active if the loss of communication with the sensor has lasted for more then 2.5 seconds. This fault is latched for the full ignition cycle. The fault will go stored on the next key cycle upon the fault not setting for longer then 2.5 seconds.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.