Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSIS3.6L - DTCS P0160 TO P0480DIAGNOSIS AND TESTINGP0457-LOOSE FUEL CAPSET CONDITION
2013 Dodge and Ram Journey Crew, AWD
Set Condition
2013 Dodge and Ram Journey Crew, AWDSECTION Set Condition
If a leak greater than 0.090" is detected by the Powertrain Control Module (PCM) for three consecutive cold start trips after a significant fuel level change, this DTC will set. One good trip turns off the MIL.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.