Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999DAKOTA SLT, 2D PICKUP, 3.9 X, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONBRAKESMAP - ROUTINE INSPECTION REFERENCE GUIDEROUTINE INSPECTION REFERENCE GUIDEROUTINE INSPECTION - UICSSTEERING AND SUSPENSION, WHEEL ALIGNMENT, WHEELS AND TIRESVALVE STEMS
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, Standard
Valve Stems
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, StandardSECTION Valve Stems
NOTE:
Most tire manufacturers suggest replacement of non-TPMS valve stems any time a new tire is installed. For TPMS valve stems, the manufacturer may require replacement of the valve stem, o-ring seals, washers, gaskets, valve cores, compression washers and/or locking nut.
| Condition | Code | Procedure |
|---|---|---|
| Bent | 2 | Suggest replacement |
| Broken | A | Require replacement |
| Cap seized | A | Require repair or replacement |
| Cut, but not leaking | 1 | Suggest replacement |
| Deteriorated (cracking, dry rot) | 1 | Suggest replacement |
| Leaking | A | Require repair or replacement |
| Missing | C | Require replacement |
| O-Ring leaking | A | Require replacement of O-Ring |
| Threads damaged | A | Require repair or replacement |
| Threads stripped | A | Require replacement |
| Valve cap missing | C | Require replacement of cap |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.