Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999DAKOTA SLT, 2D PICKUP, 3.9 X, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - TESTS W/CODESINTRODUCTIONSYSTEM DIAGNOSTICSNOTES
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, Standard
System Diagnostics: Notes
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, StandardSECTION Notes
NOTE:
If MIL does not come on for 2-3 seconds and then go off, bulb may be defective, or problem may exist on circuit (CCD Bus) between Powertrain Control Module (PCM) and instrument cluster. If problem exists with CCD Bus, this problem may be displayed when using scan tool to retrieve DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.