Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999DAKOTA SLT, 2D PICKUP, 3.9 X, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCIRCUIT PROTECTION DEVICES
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, Standard
Circuit Protection Devices
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, StandardSECTION Circuit Protection Devices
CIRCUIT PROTECTION DEVICES
| Component | Component Location |
|---|---|
| Junction Block | On left end of dash. |
| Power Distribution Center | In engine compartment, on left inner fender panel. See Figure. |
| Power Seat Circuit Breaker | In junction block. |
| Power Window Circuit Breaker | In junction block. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.