Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999DAKOTA SLT, 2D PICKUP, 3.9 X, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL COMPUTEROVERHEAD CONSOLE CONCERNSINCORRECT READING BEYOND +/- 5
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, Standard
Incorrect Reading Beyond +/- 5
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, StandardSECTION Incorrect Reading Beyond +/- 5
NOTE:
For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1A
after each repair.
If temperature reading is off by more than 5°F, ambient temperature sensor is defective. Replace ambient temperature sensor. Ambient temperature sensor is located to the right of condenser on radiator saddle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.