Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999DAKOTA SLT, 2D PICKUP, 3.9 X, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL COMPUTEROVERHEAD CONSOLE CONCERNSCMTC SHOWS FAILED
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, Standard
CMTC Shows Failed
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, StandardSECTION CMTC Shows Failed
NOTE:
For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1A
after each repair.
Using scan tool, perform AUTO SELF TEST. If CMTC shows failed, replace CMTC. If CMTC does not show failed, system is currently functioning properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.