Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999DAKOTA SLT, 2D PICKUP, 3.9 X, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTBODY INTERIORBODY CONTROL COMPUTERAUDIO SYSTEMSHORTED FRONT CHANNEL
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, Standard
Shorted Front Channel
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, StandardSECTION Shorted Front Channel
NOTE:
For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1A
after each repair.
- Disconnect amplifier 10-pin connector C2. Amplifier is located under right side of instrument panel in cowl area. Turn radio on. Using an external voltmeter, measure voltage between ground and amplifier 10-pin connector C2 terminal No. 6 (Violet wire). If voltage is 4.5-5.5 volts, go to next step. If voltage is not 4.5-5.5 volts, repair ground in Violet wire.
- Measure voltage between ground and amplifier 10-pin connector C2 terminal No. 5 (Dark Green wire). If voltage is 4.5-5.5 volts, go to next step. If voltage is not 4.5-5.5 volts, repair ground in Dark Green wire.
- Measure voltage between ground and amplifier 10-pin connector C2 terminal No. 1 (Brown/Red wire). If voltage is 4.5-5.5 volts, go to next step. If voltage is not 4.5-5.5 volts, repair ground in Brown/Red wire.
- Measure voltage between ground and amplifier 10-pin connector C2 terminal No. 2 (Dark Blue/Red wire). If voltage is 4.5-5.5 volts, replace radio. If voltage is not 4.5-5.5 volts, repair ground in Dark Blue/Red wire.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.