Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2008TOWN & COUNTRY V6-4.0LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSENGINE TORQUE SPECIFICATIONS
2008 Chrysler Town & Country V6-4.0L
Engine Torque Specifications
2008 Chrysler Town & Country V6-4.0LSECTION Engine Torque Specifications
SPECIFICATIONS - TORQUE
Lower Intake Torque Sequence
Upper Intake Torque Sequence
Tighten bolts gradually starting in the center working outward until a torque of 12 Nm (105 in. lbs.) is obtained.
Exhaust Manifold
Tighten bolts starting at the center working outward to 23 N.m (200 in. lbs.)
Main Bearing Caps
The main bearing cap bolts must be tightened in the proper sequence. First the inner main cap bolts, secondly the windage tray bolts, lastly the main cap tie (horizontal) bolts.
Install each main bearing cap and tighten inner bolts finger tight.
Tighten inner main bearing cap bolts to 20 Nm + 1/4 turn (15 ft. lbs. + 1/4 turn).
Measure crankshaft end play.Procedures
Install windage tray. Lubricate bolts with engine oil and tighten to 27 Nm + 1/4 turn (20 ft. lbs. + 1/4 turn).
Install the main cap tie (horizontal) bolts and tighten to 28 Nm (250 in. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.