Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2008TOWN & COUNTRY V6-3.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMKNOCK SENSORSERVICE AND REPAIRINSTALLATION
2008 Chrysler Town & Country V6-3.8L
Installation
2008 Chrysler Town & Country V6-3.8LSECTION Installation
3.3/3.8L
CAUTION: Torque the knock sensor to correct specification. Over or under tightening effects knock sensor performance, possibly causing improper spark control and damage to the sensor.
1. Install knock sensor (2) and bolt (3) to engine and tighten to 20 Nm (15 ft. lbs.).
2. Connect electrical connector (1) to knock sensor (2).
3. Install knock sensor cover (4).
4. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.