Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2008TOWN & COUNTRY V6-3.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHSERVICE AND REPAIRINSTALLATION
2008 Chrysler Town & Country V6-3.8L
Installation
2008 Chrysler Town & Country V6-3.8LSECTION Installation
INSTALLATION
1. Install a new manual lever oil seal (2) using socket (3).
2. Install the manual lever in the case up to the point of the TRS.
3. Install the TRS/rooster comb onto the manual lever and fully install the manual lever into the case.
4. Install the roll pin (3) to the TRS/rooster comb (1) using a pin punch (2).
5. Install the set screw (1) at manual lever (2) and tighten to 1 Nm (10 in. lbs.).
6. Install the park rod assembly (2) to the TRS/rooster comb (1) and place the park rod assembly into the guide assembly.
7. Place the park pawl pin into the park pawl tube.
8. Install the electrical connector.
9. Install the valve bodyInstallation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.