Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2008TOWN & COUNTRY V6-3.8LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL LAMPSERVICE AND REPAIRFRONT LAMP UNIT - REMOVAL
2008 Chrysler Town & Country V6-3.8L
Front Lamp Unit - Removal
2008 Chrysler Town & Country V6-3.8LSECTION Front Lamp Unit - Removal
FRONT LAMP UNIT
1. Disconnect and isolate the battery negative cable.
2. Complete removal of the front fascia is necessary to remove the front lamp unit.Front Fascia - Removal.
3. Remove the three retaining bolts (1).
4. Remove the 4 retaining bolts (3) from the front lamp/fascia support bracket and remove the bracket.
5. Pull the front lamp assembly forward to access the rear of the unit.
6. Disconnect the turn signal, marker lamp, headlamp and High Intensity Discharge Lamp (HID) connector, (if equipped) and remove the front lamp unit from its mounting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.