Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2008SEBRING CONVERTIBLE V6-2.7LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER MOTORSERVICE AND REPAIRWIPER MODULE - INSTALLATION
2008 Chrysler Sebring Convertible V6-2.7L
Wiper Module - Installation
2008 Chrysler Sebring Convertible V6-2.7LSECTION Wiper Module - Installation
INSTALLATION
1. Connect wire connector (2) at motor.
2. Place assembly into position, install the three mounting bolts (1), Tighten bolts to 11 Nm (97 in. lbs.).
3. Install the cowl screen Installation.
4. Install the wiper arms and blades Wiper Arms - Installation.
5. Connect the battery negative remote cable.
6. If necessary, adjust wiper arms Adjustments.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.