Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2008SEBRING CONVERTIBLE V6-2.7LREPAIR AND DIAGNOSISINSTRUMENT PANEL, GAUGES AND WARNING INDICATORSDASHBOARD / INSTRUMENT PANELSERVICE AND REPAIRINSTRUMENT PANEL PASSENGER SIDE BEZELREMOVAL
2008 Chrysler Sebring Convertible V6-2.7L
Removal
2008 Chrysler Sebring Convertible V6-2.7LSECTION Removal
REMOVAL
1. Remove the right instrument panel end cover Removal.
2. Remove the center console bezel Console Shifter Bezel - Removal.
3. Remove instrument panel center bezel Instrument Panel Center Bezel - Removal.
4. Remove the lower glove box Instrument Panel Glove Box - Removal.
5. Remove the retaining screws to the passenger side trim bezel.
- Two under end cap
- Four inside glove box opening
- One in center bezel opening
CAUTION: When removing the passenger side trim panel, you must slightly pry out on the front console side panels enough to release the trim panel.
6. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the passenger trim bezel and remove.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.