Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2007ASPEN 4.7 P, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSCOMMON SPECS & PROCEDURESSPECIFICATIONS INDEX
2007 Chrysler Aspen 4.7 P, RWD
Specifications Index
2007 Chrysler Aspen 4.7 P, RWDSECTION Specifications Index
ASPEN & DURANGO SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | A/C SYSTEM | ||
| Torque | TORQUE | ||
| Axle Nut/Hub Nut | |||
| Front | 185 Ft. Lbs. (251 N.m) | ||
| Rear | N/A | ||
| Battery | N/A | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | ABS BRAKE BLEEDING | ||
| Without ABS | STANDARD PROCEDURE | ||
| Disc Brakes | BASE BRAKE | ||
| Torque | TORQUE | ||
| Charging | |||
| Generator | GENERATOR RATINGS | ||
| Torque | CHARGING SYSTEM TORQUE | ||
| Drive Belts | |||
| Adjustment | N/A | ||
| Belt Routing | |||
| 3.7L/4.7L | ACCESSORY DRIVE BELT -- INSTALLATION -- 3.7L & 4.7L | ||
| 5.7L | ACCESSORY DRIVE BELT -- INSTALLATION - 5.7L | ||
| Engine Cooling | |||
| General Service Specifications | COOLING -- FILL VOLUMES | ||
| Radiator Cap Pressure | 14-18 psi | ||
| Thermostat R & I | THERMOSTAT -- ENGINE COOLANT | ||
| Water Pump R & I | PUMP-WATER | ||
| Engine Mechanical | |||
| 3.7L | |||
| Compression | CYLINDER COMPRESSION PRESSURE LEAKAGE | ||
| Oil Pressure | 4 psi at idle, 25-110 at 3000 RPM | ||
| Overhaul | 3.7L - SERVICE INFORMATION | ||
| Torque | TORQUE | ||
| 4.7L | |||
| Compression | CYLINDER COMPRESSION PRESSURE | ||
| Oil Pressure | 7 psi at idle, 35-105 psi at 3000 RPM | ||
| Overhaul | 4.7L - SERVICE INFORMATION | ||
| Torque | TORQUE SPECS | ||
| 5.7L | |||
| Compression | CYLINDER COMPRESSION PRESSURE | ||
| Oil Pressure | 4 psi at idle, 25-110 psi at 3000 RPM | ||
| Overhaul | 5.7L - SERVICE INFORMATION | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Drive Plate/Flex Plate Torque | |||
| 3.7L | 70 Ft. Lbs. (95 N.m) | ||
| 4.7L | 45 Ft. Lbs. (60 N.m) | ||
| 5.7L | |||
| Flex Plate | 70 Ft. Lbs. (95 N.m) | ||
| Flywheel | 55 Ft. Lbs. (75 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | MODULE -- FUEL PUMP | ||
| Pressure Specification | 58 psi +/- 2 psi | ||
| Fuel Pressure Test Procedure | *CHECKING THE FUEL DELIVERY SYSTEM | ||
| Fuel Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Ignition | |||
| Firing Order | |||
| 3.7L | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| 4.7L | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| 5.7L | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTING SYSTEM | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | ALIGNMENT | ||
| Torque | Front TORQUE Rear TORQUE CHART |
||
| Wheel & Tire | |||
| Lug Nut Torque | 125-145 Ft. Lbs. (173-193 N.m) | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.