Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
The procedures contained in this article include specifications, instructions and graphics needed to diagnose PCM powertrain system. The diagnostics are based on the failure condition or symptom being present at the time of diagnosis. Use the following recommendations:
- First make sure the DRBIII® is communicating with the appropriate modules; i.e., if the DRBIII® displays a No Response condition, you must diagnose the condition first before proceeding. See appropriate BASIC DIAGNOSTIC PROCEDURES article (no response with a no-start condition) or appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT (all other no response conditions).
- Using DRBIII® scan tool read Diagnostic Trouble Codes (DTC). See RETRIEVING DIAGNOSTIC TROUBLE CODES .
- If no DTCs are present, identify the customer complaint and diagnose by symptom. See appropriate TROUBLE SHOOTING - NO CODES article.
- If any DTCs are present, perform the appropriate diagnostic test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.