Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Wheel Speed Sensor (WSS): Installation
1999 Chrysler LHSSECTION Installation
- Ensure front WSS hole in steering knuckle is clean. Apply light coat of high-temperature multipurpose grease on WSS-to-steering knuckle contact areas.
- Install front WSS in steering knuckle. Ensure WSS is fully seated. Install and tighten front WSS-to-steering knuckle bolt to specification. See TORQUE SPECIFICATIONS .
- Front WSS air gap should be .017-.067" (.42-1.71 mm). Front WSS air gap is non-adjustable. To install remaining components, reverse removal procedure. Ensure locking tab on electrical connector is securely locked in place and wiring harness is properly routed. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.