Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Controller Anti-Lock Brake (Cab): Installation
1999 Chrysler LHSSECTION Installation
- To install, push CAB straight down onto connector on HCU until CAB is fully seated. Install and tighten CAB-to-HCU bolts to specification. See TORQUE SPECIFICATIONS . Reconnect pump/motor electrical connector to CAB.
- Install ICU into vehicle and initialize using scan tool. See INTEGRATED CONTROL UNIT (ICU) . Bleed base brake system and HCU. See BLEEDING BRAKE SYSTEM . Test drive vehicle to ensure base brake system and ABS operate properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.