Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chrysler CirrusFACTORY OEM SERVICE PROCEDURE
Chime Test 1A - Identifying Chime System Problems
NOTE:
Perform SYMPTOM ID TEST 1A
before proceeding with this test. For connector terminal identification and wiring diagrams, see CONNECTOR IDENTIFICATION
. Perform, after each repair, TEST VER-1A - VERIFICATION PROCEDURE
.
Diagnosis of chime system is separated into 6 categories. Identify problem(s) listed in CHIME SYSTEM DIAGNOSTIC TEST DIRECTORY table and perform indicated test(s).
CHIME SYSTEM DIAGNOSTIC TEST DIRECTORY
| Problem | Perform |
|---|---|
| Chime Inoperative At All Times | CHIME TEST 2A |
| Chime Inoperative With Exterior Lights On | CHIME TEST 3A |
| Chime Inoperative With Seat Belt Unfastened | CHIME TEST 4A |
| Chime Sounds With Seat Belt Fastened | CHIME TEST 5A |
| Chime Inoperative With Key In Ignition | CHIME TEST 6A |
| Chime Sounds With Driver Door Open & Key Removed From Ignition | CHIME TEST 7A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.