1998 Chrysler CirrusFACTORY OEM SERVICE PROCEDURE

Test VER-1A - Verification Procedure

  1. Reconnect all previously disconnected components and wiring. If battery or BCM has been disconnected, or any work has been performed on A/C system, A/C mode doors must be calibrated. Start engine and use scan tool to calibrate A/C mode doors. Do not allow vehicle to move during calibration. When calibration is complete, turn engine off and ignition on. Use scan tool to erase trouble codes.
  2. Turn ignition off and wait at least 5 seconds and then turn ignition on (engine off). Operate system that was malfunctioning to verify correct operation. If system operates properly, repair is complete. If system does not operate properly, go to SYMPTOM ID TEST 1AΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.