Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - BENDIX-6REMOVAL & INSTALLATIONREAR WHEEL SPEED SENSORREMOVAL
1993 Chrysler LeBaron Landau
Rear Wheel Speed Sensor: Removal
1993 Chrysler LeBaron LandauSECTION Removal
- Raise vehicle. Remove wheel and tire assembly. Remove sensor assembly grommet from underbody. Pull harness through hole in underbody. Unplug connector from harness. See Figure . Remove sensor grommet screw from body hose bracket, forward of trailing arm bushing.
- Remove sensor assembly clip located on inboard side of trailing arm. Remove sensor wire fastener from rear brake hose bracket. Remove outboard sensor assembly retainer nut.
- Remove sensor head screw. Carefully remove sensor. If sensor is frozen, use a hammer and punch to lightly tap edge of sensor ear, rocking sensor from side to side until free. DO NOT use pliers.
CAUTION:
Proper installation of wheel speed sensor cables is critical to continued operation of system. Ensure cables are installed in retainers. Failure to install cables in retainers may cause contact with moving parts and/or over-extension of cables, resulting in open circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.