Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - BENDIX-6REMOVAL & INSTALLATIONMODULATOR ASSEMBLYINSTALLATION
1993 Chrysler LeBaron Landau
Modulator Assembly: Installation
1993 Chrysler LeBaron LandauSECTION Installation
- Install modulator assembly in vehicle. See Fig 1 . Use protruding tab on assembly to locate and hold assembly in place. Ensure bracket is held by front mounting bolt. Install, but DO NOT tighten, modulator assembly bracket to fender shield bolt. Raise vehicle on hoist. Install modulator assembly bracket mounting bolt near junction block. Tighten both lower mounting bracket bolts to 21 ft. lbs. (28 N.m).
- Install 4 hydraulic brake tubes to modulator assembly, and tighten fittings to 12 ft. lbs. (16 N.m). Reconnect 10-pin modulator assembly connector. Lower vehicle, and install 2 master cylinder supply tubes to modulator assembly. Tighten modulator assembly and master cylinder fittings to 12 ft. lbs. (16 N.m). Tighten modulator-to-fender splash shield bolt to 21 ft. lbs. (28 N.m).
- Bleed brake system. See BLEEDING BRAKE SYSTEM . Install acid shield and battery tray. Install battery, and connect battery cables.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.