Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - BENDIX-6BLEEDING BRAKE SYSTEMMANUAL BLEEDING
1993 Chrysler LeBaron Landau
Manual Bleeding
1993 Chrysler LeBaron LandauSECTION Manual Bleeding
- Fill master cylinder. Install clear vinyl bleed hose onto right rear bleed valve. Place other end of hose in clean transparent container.
- Partially fill container with clean brake fluid. Submerge end of hose in fluid. Open bleed valve 1-2 turns. Slowly depress brake pedal through its full travel.
- Close bleed valve. Release pedal. Pump pedal several times to push air toward wheel cylinders. Repeat procedure until flow of brake fluid is clear and free of bubbles. Proceed to next bleed valve of brake bleeding sequence. See BRAKELINE BLEEDING SEQUENCE table.
BRAKELINE BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| All Models | RR, LF, LR, RF |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.