SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - BENDIX-4REMOVAL & INSTALLATIONMODULATOR ASSEMBLYREMOVAL
1993 Chrysler LeBaron Landau

Modulator Assembly: Removal

1993 Chrysler LeBaron LandauSECTION Removal
  1. Center vehicle on hoist, or raise front of vehicle on jackstands. Disconnect and remove battery, battery tray and acid shield covering modulator assembly. Disconnect differential pressure switch (Delta "P" switch) connector from junction block. See Fig 1 . Remove top modulator assembly bracket-to-fender shield mounting bolt.
  2. Disconnect 2 master cylinder supply tubes at modulator assembly. Loosen 2 tubes at master cylinder and set aside. Ensure tubes are not kinked. Raise vehicle on hoist. From under vehicle, disconnect modulator assembly 10-pin connector. Remove 4 remaining hydraulic tubes from modulator assembly.
  3. Remove modulator assembly bracket mounting bolt closest to junction block. Loosen, but DO NOT  remove, bracket mounting bolt nearest radiator. Lower vehicle. Lift modulator assembly and bracket out of vehicle.
Fig 1: Locating Differential Pressure Switch (Delta "P" Switch)
G93I41259Courtesy of CHRYSLER CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.