Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - BENDIX-4DIAGNOSIS & TESTINGDRB-II TEST FUNCTIONSENTERING DRB-II MAIN MENU
1993 Chrysler LeBaron Landau
Entering DRB-II Main Menu
1993 Chrysler LeBaron LandauSECTION Entering DRB-II Main Menu
- Ensure ignition is off. Attach DRB-II to Chrysler Collision Detection (CCD) data link connector. Data link connector is located behind fuse access cover on lower section of dash panel, left of steering column. See Figure . Turn ignition switch to RUN position.
- All DRB-II character positions will glow and copyright information will appear on screen for a few seconds. DRB-II main menu will appear after a few seconds. If DRB-II screen is blank, NO RESPONSE message is displayed, or any error messages appear, refer to DRB-II PROBLEMS & ERROR MESSAGES .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.