Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - BENDIX-4BLEEDING BRAKE SYSTEMBLEEDING MODULATOR ASSEMBLY
1993 Chrysler LeBaron Landau
Bleeding Modulator Assembly
1993 Chrysler LeBaron LandauSECTION Bleeding Modulator Assembly
CAUTION:
Ensure manual bleeding procedure is performed before bleeding modulator assembly.
- To gain access to 6 bleed screws located on modulator assembly, remove battery, battery tray and acid shield. Connect battery to vehicle using jumper cables.
- Ensure all fluid lines are installed and correctly torqued. Bleed base brake system using standard manual procedure.
- Connect DRB-II to Blue 6-pin CCD data link connector, located behind fuse access cover on lower section of dash panel, left of steering column. See Fig 1 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.