Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAX LSREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP
2025 Chevrolet Trax LS
Programming And Setup
2025 Chevrolet Trax LSSECTION Programming And Setup
- Diagnostic Information and Procedures
- Repair Instructions
- A11 Radio: Programming and Setup
- A26 HVAC Controls: Programming and Setup
- B174W Frontview Camera - Windshield: Programming and Setup
- B218L Side Object Sensor Module - Left: Programming and Setup
- K9 Body Control Module: Programming and Setup
- K20 Engine Control Module: Programming and Setup
- K29F Seat Heating Control Module - Front: Programming and Setup
- K33 HVAC Control Module: Programming and Setup
- K36 Inflatable Restraint Sensing and Diagnostic Module: Programming and Setup
- K36 Inflatable Restraint Sensing and Diagnostic Module: Configure New Module
- K39 Liftgate Control Module: Programming and Setup
- K43 Power Steering Control Module: Programming and Setup
- K56 Serial Data Gateway Module: Programming and Setup
- K61 Sunroof Control Module: Programming and Setup
- K71 Transmission Control Module or Q8 Control Solenoid Valve Assembly: Programming and Setup (6T40 (MNH MNK))
- K73 Telematics Communication Interface Control Module: Programming and Setup (UE1)
- K73 Telematics Communication Interface Control Module: Programming and Setup (UES)
- K84 Keyless Entry Control Module: Programming and Setup
- K85 Passenger Presence Module: Programming and Setup
- K89 Immobilizer Control Module: Programming and Setup
- K111 Fuel Pump Driver Control Module: Programming and Setup
- K160 Brake System Control Module: Programming and Setup
- K182 Parking Assist Control Module: Programming and Setup
- P16 Instrument Cluster: Programming and Setup (UDC)
- P16 Instrument Cluster: Programming and Setup (URO)
- Service Programming System (SPS)
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.