SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2022TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSAIR INLET GRILLE PANEL REPLACEMENT
2022 Chevrolet Traverse High Country, FWD

Air Inlet Grille Panel Replacement

2022 Chevrolet Traverse High Country, FWDSECTION Air Inlet Grille Panel Replacement
GM4744682Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Windshield Wiper Arm Replacement 
  2. Air Inlet Grille Panel Extension Replacement (Left Side) , or Air Inlet Grille Panel Extension Replacement (Right Side) 
  3. Hood Rear Outer Air Inlet Seal Replacement
1 Air Inlet Grille Panel Retainer [8x]
2 Air Inlet Grille Panel

Procedure

  1. Using an appropriate tool, release the air inlet grille panel from the windshield lower molding.
  2. Lift up the front edge of the air inlet grille panel, slide the grille panel forward from both hood hinges.
  3. Disconnect the windshield washer nozzle hose from the windshield washer hose.
  4. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.