Rear Side Door Outside Handle Replacement (Without ATH)

2019 Chevrolet Trax Premier, AWDSECTION Rear Side Door Outside Handle Replacement (Without ATH)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2177979
Callout Component Name
Preliminary Procedures 
Remove the rear side door lock cylinder/blank opening cover. Refer to Rear Side Door Lock Cylinder Opening Cover Replacement .
1 Rear Side Door Outside Handle

Procedures

  1. Check the handle should stay in the open position.
  2. Remove the outside door handle by sliding rearwards and then out in a swinging motion.
  3. While screwing in the screw for the lock cylinder hold the handle in the open position, this will avoid the door handle from snapping once the spring pressure is relieved and the door handle returns to the close position.
NOTE:

Inspect the door locking system for proper operation before installing the door trim.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.