SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 99 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSREAR SIDE DOOR LOCK CYLINDER OPENING COVER REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Rear Side Door Lock Cylinder Opening Cover Replacement

2019 Chevrolet Trax Premier, AWDSECTION Rear Side Door Lock Cylinder Opening Cover Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2476194
Callout Component Name
1 Rear Side Door Lock Cylinder Opening Cover

Procedure

  1. Remove the front side door lock cylinder/blank screw access plug.
  2. Pull and hold the door handle in the open position.
  3. Do Not remove the door lock cylinder/blank screw completely from the housing. Unscrew the screw to a hard stop, remove the cylinder/blank.
  4. Release the door handle, at this point the door handle should stay in the open position.
  5. Remove the door lock cylinder/blank assembly.
  6. Remove the door lock cylinder/blank cover (1)
NOTE:
  1. Remove the rear side door lock cylinder/blank, it not necessary to remove the outside door handle.
  2. Use a small flat-bladed tool to release the door lock cylinder opening cover retainers location on both sides.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.