SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 99 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSREAR SIDE DOOR OUTSIDE HANDLE BRACKET REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Rear Side Door Outside Handle Bracket Replacement

2019 Chevrolet Trax Premier, AWDSECTION Rear Side Door Outside Handle Bracket Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2770895
Callout Component Name
Preliminary Procedure 
Remove the rear side door outside handle. Refer to Rear Side Door Outside Handle Replacement (Without ATH) Rear Side Door Outside Handle Replacement (With ATH) .
1 Rear Side Door Outside Handle Bracket Screw
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Release the rear outside door handle rod clip so that the handle rod can be free from the door latch assembly
  2. Remove the rear outside door handle bracket and handle rods as assembly.

Tighten 
4 N.m (35 lb in)
2 Rear Side Door Outside Handle Bracket

Procedure

  1. Transfer components as necessary.
  2. In order to prevent outside handle lever pre-load, lock, outside handle, handle bracket and cover/cap shall be fully secured to the door prior to securing integral lock clip to outside handle rod. Integral lock clip shall be in the full up position while securing to outside handle rod. Refer to Rear Side Door Outside Handle Rod Adjustment .
NOTE:

Inspect the door lock system for proper operation before installing the door trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.