SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 99 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE DOOR LATCH REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Front Side Door Latch Replacement

2019 Chevrolet Trax Premier, AWDSECTION Front Side Door Latch Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2770786
Callout Component Name

Preliminary Procedure

  1. Remove the front side door outside handle bracket. Refer to Front Side Door Outside Handle Bracket Replacement .
  2. Remove the front side door window rear guide. Refer to Front Side Door Window Rear Guide Replacement .
1 Front Side Door Latch Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .

Procedures

  1. Release the inside door handle cable from the retainers.
  2. Remove the front side door lock rod theft cover, if equipped
  3. Disconnect the front side door latch electrical connector.

Tighten 
10 N.m (89 lb in)
2 Front Side Door Latch Assembly

Procedure

  1. Transfer the front side door lock rods and cable.
  2. In order to prevent outside handle lever pre-load, lock, outside handle, handle bracket and cover/cap shall be fully secured to the door prior to securing integral lock clip to outside handle rod. Integral lock clip shall be in the full up position while securing to outside handle rod. Refer to Front Side Door Outside Handle Rod Adjustment .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.