SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 117 (FIXED AND MOVEABLE WINDOW SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REAR GUIDE REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Front Side Door Window Rear Guide Replacement

2019 Chevrolet Trax Premier, AWDSECTION Front Side Door Window Rear Guide Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2780637
Callout Component Name
WARNING:

Refer to Glass and Sheet Metal Handling Warning .

Preliminary Procedures

  1. Remove the front side door trim. Refer to Front Side Door Trim Replacement (Buick)Front Side Door Trim Replacement (Chevrolet) .
  2. Remove the front side door window garnish molding. Refer to Front Side Door Window Garnish Molding Replacement
  3. Loosen the front side door rear guide, Do not remove. Refer to Front Side Door Window Rear Guide Replacement 
1 Front Side Door Window Regulator Guide Nuts (Qty: 2)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Use masking tape, tape off the outer door frame, applique and the front side door window outer sealing strip to prevent scratching.
  2. Remove the front side door water deflector.
  3. Loosen nuts so that the window can be removed from the guides.
  4. In order to remove the window out of the frame, carefully grasp and tilt the window as you guide the window up and forward.

Tighten 
10 N.m (89 lb in)
2 Front Side Door Window

Procedure

  1. Lower the window to align the guide nuts with the access holes in the inner door panel.
  2. Do not operate the regulator motor without supporting the window. Ensure that the window remains in the guide when operating the regulator motor.
  3. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guide.
  4. Inspect the window for proper operation before installing the trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.