Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSENGINE COOLANT FAN SHROUD REPLACEMENT (LUV)

2019 Chevrolet Trax Premier, AWD

Engine Coolant Fan Shroud Replacement (LUV)

2019 Chevrolet Trax Premier, AWDSECTION Engine Coolant Fan Shroud Replacement (LUV)

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Callout

Component Name

Preliminary Procedure

Remove the radiator surge tank. Refer to Radiator Surge Tank Replacement (LUV, 2H0) Radiator Surge Tank Replacement (LE2) .
Unclip transmission cooler lines from shroud if equipped.
Unclip radiator surge tank outlet hose from fan shroud.
Disconnect the electrical connectors from the fan shroud.
Remove the radiator inlet hose. Refer to Radiator Inlet Hose Replacement (LUV) Radiator Inlet Hose Replacement (2HO) Radiator Inlet Hose Replacement (LE2) .
Remove the front compartment front center insulator. Refer to Front Compartment Front Center Insulator Replacement .
Remove the radiator outlet hose. Refer to Radiator Outlet Hose Replacement (LUV) Radiator Outlet Hose Replacement (2H0) Radiator Outlet Hose Replacement (LE2) .

Engine Coolant Fan Shroud Bolt (Qty: 3)

CAUTION:

Refer to Fastener Caution .

Engine Coolant Fan Shroud

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.