Engine Coolant Fan Replacement (LE2)

2019 Chevrolet Trax Premier, AWDSECTION Engine Coolant Fan Replacement (LE2)
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM4122276
Callout Component Name
Preliminary Procedure 
Engine Coolant Fan Shroud Replacement (2H0) Engine Coolant Fan Shroud Replacement (LUV) Engine Coolant Fan Shroud Replacement (LE2) 
1 Engine Coolant Fan Bolt [3x]
CAUTION:

Refer to Fastener Caution .


Tighten 
6 N.m (53 lb in)
2 Engine Coolant Fan Resistor
Procedure 
Unclip engine coolant fan resistor from the shroud.
3 Resistor Wiring Harness.
Procedure 
Unclip resistor harness from the shroud.
4 Engine Coolant Fan Shroud
5 Engine Coolant Fan - Motor Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.