SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Windshield Washer Solvent Container Replacement

2019 Chevrolet Trax Premier, AWDSECTION Windshield Washer Solvent Container Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2844462
Callout Component Name

Preliminary Procedure

  1. Remove the windshield washer solvent container filler tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement .
  2. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Chevrolet)Front Wheelhouse Liner Replacement (Buick) .
  3. Disconnect the windshield washer pump hose.
1 Windshield Washer Solvent Container Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
5 N.m (44 lb in)
2 Windshield Washer Solvent Container

Procedure

  1. Remove washer solvent container from the front compartment panel assembly and lower the washer container from the wheelhouse compartment.
  2. Drain the windshield washer solvent into a suitable clean container.
  3. Transfer the component parts as needed.
  4. Install a new grommet prior to installing the windshield washer pump into the washer solvent container.
  5. Fill the windshield washer solvent container after installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.