SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER FILLER TUBE REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Windshield Washer Solvent Container Filler Tube Replacement

2019 Chevrolet Trax Premier, AWDSECTION Windshield Washer Solvent Container Filler Tube Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
GM2844460
Callout Component Name
1 Windshield Washer Solvent Container Filler Tube Assembly Retainer
2 Windshield Washer Solvent Container Filler Tube Assembly

Procedure

  1. Reach into the driver side of the engine compartment at the position where the windshield washer solvent container filler tube enters the windshield washer solvent container.
  2. Grasp the windshield washer solvent container filler tube where the filler tube enters the windshield washer solvent container.
  3. Twist the windshield washer solvent container fill tube slightly back and forth while pulling outward from the windshield washer solvent container.
  4. Remove the windshield washer solvent container filler tube.
  5. Inspect and replace any damaged O-ring.
  6. Use full strength windshield washer fluid at the windshield washer solvent container filler tube seal upon re-assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.