SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TRAX PREMIER, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD WIPER MOTOR REPLACEMENT
2019 Chevrolet Trax Premier, AWD

Windshield Wiper Motor Replacement

2019 Chevrolet Trax Premier, AWDSECTION Windshield Wiper Motor Replacement
GM2844478Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Trax) Air Inlet Grille Panel Replacement (Encore) 
  2. Remove the windshield wiper transmission. Refer to Windshield Wiper Transmission Replacement 
1 Windshield Wiper Motor Bracket Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .
2 Windshield Wiper Motor

Procedure

  1. Use a wiper linkage separator or similar tool, separate the transmission drive link from the wiper motor crank arm ball stud.
  2. Remove the windshield wiper motor from the wiper transmission.
  3. Position the new windshield wiper motor to the transmission.
  4. Align the transmission links to the wiper motor crank arm.
  5. Use a wiper linkage installer or similar tool, to install the transmission drive link onto the wiper motor crank arm ball stud.
    NOTE:

    Apply a small amount of grease to the inner cup on the transmission link to aid in installation.

Special Tools

  • J - 39232  Wiper Linkage Separator
  • J-39529  Wiper Linkage Installer

For equivalent regional tools. Refer to Special Tools 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.