Windshield Wiper Transmission Replacement

2019 Chevrolet Trax Premier, AWDSECTION Windshield Wiper Transmission Replacement
GM2844484Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Open and support the hood assembly.
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Trax) Air Inlet Grille Panel Replacement (Encore) .
1 Windshield Wiper Transmission Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Windshield Wiper Transmission

Procedure

  1. Lift the windshield wiper transmission from the plenum brackets.
  2. Disconnect the electrical connector from the windshield wiper motor.
  3. Remove the windshield wiper transmission from the plenum.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.