SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 60 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSBRAKE PEDAL POSITION SENSOR REPLACEMENTINSTALLATION PROCEDURE
2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Installation Procedure

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2511817Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure the fork of the brake pedal position sensor is positioned over the brake pedal post.

    Install the brake pedal position sensor to the brake pedal bracket.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the brake pedal position sensor bolt (1) and tighten to 3 N.m (27 lb in).
  3. Connect the brake pedal position sensor electrical connector.
  4. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
  5. Install the instrument panel lower trim pad cover. Refer to Instrument Panel Lower Trim Pad Cover Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.