Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2019TAHOE LS, 4WD, GAS/ETHANOLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 78 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSINSTRUMENT PANEL LOWER TRIM PAD COVER REPLACEMENT

2019 Chevrolet Tahoe LS, 4WD, Gas/Ethanol

Instrument Panel Lower Trim Pad Cover Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Instrument Panel Lower Trim Pad Cover Replacement

WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.

Callout	Component Name
Preliminary Procedures Disable the SIR system. SIR Disabling and Enabling Remove the instrument panel outer trim cover left side. Instrument Panel Outer Trim Cover Replacement Remove the instrument panel fuse block access hole cover. Instrument Panel Fuse Block Access Hole Cover Replacement (Without AAL) Instrument Panel Fuse Block Access Hole Cover Replacement (With AAL) Reposition the diagnostic line connector from the instrument panel lower cover bracket.
1	Instrument Panel Lower Trim Pad Fastener (Qty: 7) CAUTION: Refer to Fastener Caution .
2	Instrument Panel Lower Trim Pad Cover Clip (Qty: 4)
3	Instrument Panel Lower Trim Pad Cover Procedure Use a flat bladed plastic trim tool in order to disengage the clips securing the lower trim pad cover to the instrument panel assembly. Disconnect the electrical connectors. When replacing the instrument panel lower trim pad, transfer all necessary components.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.