Rear Window Washer Nozzle Replacement

2019 Chevrolet Tahoe LS, 4WD, Gas/EthanolSECTION Rear Window Washer Nozzle Replacement
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
GM2502678Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary ProcedureΒ 
Remove the inside high mount stop lamp. Refer to High Mount Stop Lamp Replacement (Sedan)High Mount Stop Lamp Replacement (Hatchback) .
1 Rear Window Washer Nozzle

Procedure

  1. Access the rear window washer nozzle through the hole in behind the high mounted stop lamp.
  2. Disconnect the washer hose from the spout.
  3. Pinch the two tabs on the rear window washer nozzle and push the nozzle up through the liftgate hole.
  4. Remove the rear window washer nozzle from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.