SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSIMMOBILIZER SYSTEMREPAIR INSTRUCTIONSTHEFT DETERRENT MODULE REPLACEMENT (WITH BTM)
2016 Chevrolet Impala LS, 3.6L Eng VIN N

Theft Deterrent Module Replacement (With BTM)

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Theft Deterrent Module Replacement (With BTM)
Fig 1: Theft Deterrent Module (With BTM)
GM2915796Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the front floor console compartment. Refer to Front Floor Console Compartment Replacement .
1 Theft Deterrent Module Fastener (Qty: 2)
CAUTION: Refer to Fastener Caution .
2 Theft Deterrent Module

Procedure

  1. Disconnect the electrical connector.
  2. Disengage tabs and slide forward to remove.
  3. Refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.