Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINSTRUMENT PANEL AND CONSOLE TRIMREPAIR INSTRUCTIONSFRONT FLOOR CONSOLE COMPARTMENT REPLACEMENT

2016 Chevrolet Impala LS, 3.6L Eng VIN N

Front Floor Console Compartment Replacement

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Front Floor Console Compartment Replacement

Fig 1: Front Floor Console Compartment

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front seat vent fan switch, if equipped. Refer to Front Seat Vent Fan Switch Replacement . Remove the vehicle stability control system switch, if equipped. Refer to Vehicle Stability Control System Switch Replacement . Remove the transmission control lever knob. Refer to Transmission Control Lever Knob Replacement .
1	Front Floor Console Rear Compartment Liner Procedure Remove the liner to access the fasteners
2	Front Floor Console Compartment Bolt (Qty: 6) CAUTION: Refer to Fastener Caution .
3	Front Floor Console Compartment Procedures Lift from the front and carefully pull out the rear lip from the armrest bracket. Disconnect the electrical connections. Transfer all necessary components.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.