SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE BASE, 2D CONVERTIBLE, STANDARD TRANS, TRANS MFR CD 6L85M/MM6REPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSBATTERY POSITIVE AND NEGATIVE CABLE REPLACEMENT (LS3)REMOVAL PROCEDURE
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6

Removal Procedure

2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6SECTION Removal Procedure
  1. Disconnect the negative cable lead from the battery. Refer to Battery Negative Cable Disconnection and Connection (LS7 or LS9) , Battery Negative Cable Disconnection and Connection (LS3) .
    2. Fig 1: View Of Battery & Related Components
    GM1705066Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the positive cable lead (2) from the battery.
  3. Remove the battery tray. Refer to Battery Tray Replacement .
  4. Remove the battery positive cable to fuse/relay center nut (6) and disconnect the cable (5) from the stud.
  5. Remove the battery ground cable nut (4) and disconnect the cable (3) from the stud.
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Remove the starter. Refer to Starter Replacement .
    8. Fig 2: View Of Battery Cables & Bolts
    GM1705068Courtesy of GENERAL MOTORS COMPANY
  8. Remove the battery positive/negative cable to engine bolt (3).
  9. Remove the battery positive/negative cable from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.