Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE BASE, 2D CONVERTIBLE, STANDARD TRANS, TRANS MFR CD 6L85M/MM6REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSBATTERY, CHARGING SYSTEM AND STARTING SYSTEM
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6
Battery, Charging System And Starting System
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6SECTION Battery, Charging System And Starting System
- Specifications
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC B1325, B1327, B1328, B1330, B1517, C0800, C0895, C0899, C0900, P0560, P0562, P0563, P129B, or P129C
- DTC P0615, P0616, or P0617
- DTC P0621
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0622
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0625 or P0626
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P1668
- DTC P2500 or P2501
- Symptoms - Engine Electrical
- Battery Inspection/Test
- Battery Charging
- Battery Electrical Drain/Parasitic Load Test
- Charging System Test
- Generator Noise Diagnosis
- Starter Solenoid Does Not Click
- Starter Solenoid Clicks, Engine Does Not Crank
- Engine Cranks Slowly
- Starter Noise Diagnosis
- Repair Instructions
- Battery Negative Cable Disconnection and Connection (LS7 or LS9)
- Battery Negative Cable Disconnection and Connection (LS3)
- Battery Positive and Negative Cable Replacement (LS3)
- Battery Positive and Negative Cable Replacement (LS7,LS9 or LS3 with Z52)
- Battery Negative Cable Replacement (7.0L)
- Battery Positive Cable Replacement (7.0L)
- Battery Replacement (LS7 or LS9)
- Battery Replacement (LS3)
- Battery Tray Replacement
- Starter Replacement
- Generator Bracket Replacement
- Generator Replacement (LS3 or LS7)
- Generator Replacement (LS9)
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.