2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6FACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LS7 or LS9) , Battery Negative Cable Disconnection and Connection (LS3) .
  2. Disconnect the positive battery cable from the battery.
  3. Remove the rear compartment carpet. Refer to Rear Compartment Floor Panel Carpet Replacement (Convertible) , Rear Compartment Floor Panel Carpet Replacement (Coupe) .
  4. Remove the passenger rear compartment front side trim panel. Refer to Rear Compartment Side Trim Panel Replacement .
  5. Remove the right door sill plate. Refer to Door Sill Plate Replacement .
  6. Lift up the carpet to access the battery cables.
    7. Fig 1: View Of Positive Battery Cable Retainers
    GM1672703Courtesy of GENERAL MOTORS COMPANY
  7. Remove the positive battery cable retainers.
    8. Fig 2: View Of Positive Cable & Grommet
    GM1672702Courtesy of GENERAL MOTORS COMPANY
  8. Open the carpet on the fuse/relay center.
    9. Fig 3: View Of Positive Battery Cable Lead & Nut
    GM1704615Courtesy of GENERAL MOTORS COMPANY
  9. Remove the positive battery cable nut (1) from the fuse/relay center stud.
  10. Remove the positive battery cable lead (2) from the fuse/relay center stud.
  11. Remove the positive battery cable grommet from the dash panel.
  12. Pull the positive cable through the dash panel.
  13. Remove the positive battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.