Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 632 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING ASSIST MOTOR REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic
Removal Procedure
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2011 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
- Cover the carpet in order to capture any lubricant that may drip from the steering column or the power steering assist motor.
- Remove the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement .
- Note the location and the routing of the tie strap that holds the power steering assist motor wires to the steering column.
- Remove the tie strap from the steering column.
Discard the tie strap.
- Disconnect the power steering assist motor electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.